Float drainscontain a float within the device that normally seats on a small orifice. When liquid enters the drain the float rises off its seat, exposing the orifice and allowing liquid to discharge through the stem. As the liquid level drops, the float re-seats and seals the orifice. These drains operate only when a. .
Pneumatic drainsare simple and robust.They rely on a pneumatic pilot signal to operate and use a ball valve to eject the moisture from the air system. As mentioned in the video, the. .
Electronic drainsrequire electricity and, unlike the other drain models, can be adjusted for frequency and duration of the discharge time. Electronic drainsincorporate a solenoid.
[pdf] A pneumatic rock drill uses compressed air, a piledriver and a drill bit to pound into and pulverize hard surfaces. This powerful, efficient tool combines superior. .
An air-powered rock drill can meet the productivity and performance requirements of companies in a wide range of industries. .
As your full-service equipment rental partner, Herc Rentals can provide the best possible rental experience. All our rentals come from leading manufacturers with. .
Cut through the most challenging materials with a powerful, efficient air-powered rock drill from Herc Rentals. The knowledgeable rental specialists at any of our.
[pdf] 
Before diving into whether or not you should invest in a dual-rod machine, you need to know a little bit about the technology and its advantages for drilling in rock. “Dual-rod systems use two independently controlled drill rods— one within the other — during operation,” explained Michael. “While drilling out the pilot. .
One of the first factors to consider before choosing a dual-rod machine is the type of rock you’re working in. “Dual-rod drills are efficient in light- and. .
For most utility HDD work, small jobsites and the ability to quickly set up and tear down are essential to a crew’s operating efficiency. “Dual-rod machines can often be transported on. .
As you can see, the decision to add a dual-rod machine if more than 50% of your work is in rock, or to add a single-rod machine if less than 25% of your work is in rock, is pretty straightforward. However, if you fall someplace in the middle, then you have a lot to. .
Of course, how long a bore takes can often depend on the operator’s skills running the drill. Michael said the operator’s capabilities on the drill is another critical factor to consider when deciding between a single-rod and a dual-rod machine..
[pdf] 
