A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud)..
A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud)..
In down-the-hole drilling a drill rod is fitted with a hammer at its lower end. The hammer, which is mounted on the drill bit, is activated through the addition of compressed air and driven into the ground – simultaneously rotating and impacting..
Down-the-Hole (DTH) drilling is a technique used to create deep, precise holes in hard rock and challenging ground conditions. In this method, the hammer and drill bit are placed at the bottom of the drill string, directly engaging with the rock.
[pdf] Laser cutting is a widely used laser processing technology globally. Its use dates back to the 1970s when it was first used for cutting purposes. The rise and popularity of third-generation laser technology in the early 21st century have made laser cutting increasingly popular in processing materials like sheet metal,. .
Laser cutting involves the use of a high-power and high-density laser beam that is focused on the workpiece, causing the material at the irradiated area to melt, vaporize, ablate, or reach its ignition point. The melted material is then removed through high-speed. .
When laser cutting, the choice of cutting gas depends on the material being cut. The selection of the cutting gas and its pressure significantly impact the quality of the laser cutting. .
A comprehensive consideration of the laser power, auxiliary gas type, pressure, and flow rate is necessary when selecting an air compressor for a laser cutting machine. This is.
[pdf] Key tasks include changing oil and filters, cleaning air filters and cooling systems, inspecting motors and wiring, and ensuring proper operation of key components. Daily maintenance should focus on cleaning, monitoring performance, and adjusting load..
Key tasks include changing oil and filters, cleaning air filters and cooling systems, inspecting motors and wiring, and ensuring proper operation of key components. Daily maintenance should focus on cleaning, monitoring performance, and adjusting load..
Mount a thermometer in the compressor room. Increase ventilation if room temperature exceeds operating limits. Inspect and remove/vacuum loose dust from inlet filters. Frequency depends on ambient dust load. Inspect and vacuum ambient side of coolers. Frequency depends on ambient dust load.
[pdf] 
