Most “sequencers” on the market have been designed to work with screw (or reciprocating) compressors, “positive-displacement” type.. .
Fifteen years ago, I performed a Level 1 audit on a compressed air system with four 800 HP Joy TA centrifugal compressors. See Figure 1 for the system, as found in 2002. Three were running in parallel, with local controls, and one running in a segmented part of. .
Since performance degrades as the inlet valve closes back, 15% in this example project, one might suggest a hybrid system using a screw compressor for trim with the centrifugal. .
Picture two draft-horses, both pulling evenly on the same plow, in parallel. To make this happen, they need to be harnessed correctly,. .
Some load-sharing algorithms only balance the compressors. They don’t turn off a compressor at the point there is sufficient turn-down. This is okay for systems with flat loads. But if demand floats, a master control system able to start and stop, along.
[pdf] 