A tunnel boring machine (TBM), also known as a "mole" or a "worm", is a machine used to excavate tunnels. TBMs are an alternative to drilling and blasting methods and "hand mining", allowing more rapid excavation through hard rock, wet or dry soil, or sand (although each requires specialized TBM technologies). TBM-bored tunnel cross-sections extend up to 17.6 meters (58 ft. HistoryThe was developed by Sir to excavate the in 1825. However, this was only the invention of the shield concept and did not involve the constructio. .
TBMs typically consist of a rotating cutting wheel in front, called a cutter head, followed by a main bearing, a thrust system, a system to remove excavated material (muck), and support mechanisms. Machines v.
[pdf] A tunnel boring machine (TBM), also known as a "mole" or a "worm", is a machine used to excavate tunnels. TBMs are an alternative to drilling and blasting methods and "hand mining", allowing more rapid excavation through hard rock, wet or dry soil, or sand (although each requires specialized TBM technologies). TBM-bored tunnel cross-sections extend up to 17.6 meters (58 ft. HistoryThe was developed by Sir to excavate the in 1825. However, this was only the invention of the shield concept and did not involve the constructio. .
TBMs typically consist of a rotating cutting wheel in front, called a cutter head, followed by a main bearing, a thrust system, a system to remove excavated material (muck), and support mechanisms. Machines v.
[pdf] 
A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud)..
A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud)..
In down-the-hole drilling a drill rod is fitted with a hammer at its lower end. The hammer, which is mounted on the drill bit, is activated through the addition of compressed air and driven into the ground – simultaneously rotating and impacting..
Down-the-Hole (DTH) drilling is a technique used to create deep, precise holes in hard rock and challenging ground conditions. In this method, the hammer and drill bit are placed at the bottom of the drill string, directly engaging with the rock.
[pdf] 
