Working principle and explanation of down-the-hole drill

A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud).. A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud).. In down-the-hole drilling a drill rod is fitted with a hammer at its lower end. The hammer, which is mounted on the drill bit, is activated through the addition of compressed air and driven into the ground – simultaneously rotating and impacting.. Down-the-Hole (DTH) drilling is a technique used to create deep, precise holes in hard rock and challenging ground conditions. In this method, the hammer and drill bit are placed at the bottom of the drill string, directly engaging with the rock. [pdf]

Crawler DTH Drilling Rig Configuration and Structure

1. Prepare the rock-drilling cavern, the specifications of which can be determined according to the method of drilling. Generally speaking, the height of the cavity is 2.6-2.8 meters when drilling a horizontal hole with a down-the-hole drill. When drilling upward, downward, or inclined holes, the width of the cavity is. . 1. When starting to work, carefully check whether the gas and water pipelines are firmly connected. Check for air leaks and water leaks. 2. Check whether the lubricator has been. . When opening the hole, start the motor first, and pull the push handle of the manipulator after the transfer is normal. Make it get proper. [pdf]

Structure diagram of screw air compressor pressure relief valve

Under normal conditions, a pressure switch or transducer controls the air pressure in a compressor. When the pressure switch reaches its cut-out set pressure, the compressor stops compressing air (unload) until it reaches the cut-in set pressure and starts compressing air again (load). The compressor cannot. . A pressure relief valve in an air compressor opens when excessive pressure builds up inside the compressor, or the valve fails. . A pressure relief valve may not come with a pressure vessel purchased separately from the air compressor. It is crucial to add a pressure relief valve to ensure safe operation. There are. [pdf]