Before diving into whether or not you should invest in a dual-rod machine, you need to know a little bit about the technology and its advantages for drilling in rock. “Dual-rod systems use two independently controlled drill rods— one within the other — during operation,” explained Michael. “While drilling out the pilot. .
One of the first factors to consider before choosing a dual-rod machine is the type of rock you’re working in. “Dual-rod drills are efficient in light- and. .
For most utility HDD work, small jobsites and the ability to quickly set up and tear down are essential to a crew’s operating efficiency. “Dual-rod machines can often be transported on. .
As you can see, the decision to add a dual-rod machine if more than 50% of your work is in rock, or to add a single-rod machine if less than 25% of your work is in rock, is pretty straightforward. However, if you fall someplace in the middle, then you have a lot to. .
Of course, how long a bore takes can often depend on the operator’s skills running the drill. Michael said the operator’s capabilities on the drill is another critical factor to consider when deciding between a single-rod and a dual-rod machine..
[pdf] A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud). The DTH hammer is one of the fastest ways to drill hard rock. The system is thought to have been invented independently by Stenuick. Origin of the nameDTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes. .
In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the flui. .
A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the quarry face in order to place the drill hole in.
[pdf] 
This is job No. 1. It doesn’t matter how regular you are about maintenance if the person handling the tools doesn’t know what he’s doing. Says Caho: “You need someone who’s actually trained to do it.” From what Caho has seen, that’s easier said than done these days. “One of the bigger problems is that a lot of. .
If you’re maintaining your rig properly, this should be a regular part of your routine. “Those should be checked every day, or even throughout the. .
A checklist creates a sense of organization and accountability on the jobsite. “I’m a big believer in a daily inspection form that has been made up by the company,” Caho admits. “Almost. .
This has become an increasingly important factor in rig maintenance. “Make sure you’re using the specific fluids that the manufacturer or your company has required,” Caho. .
There’s a tendency to take shortcuts when it comes to wearing safety gear. Don’t do it. Personal protective equipment can’t be viewed as an option. You always want to be dressed in a way.
[pdf] 