Most “sequencers” on the market have been designed to work with screw (or reciprocating) compressors, “positive-displacement” type.. .
Fifteen years ago, I performed a Level 1 audit on a compressed air system with four 800 HP Joy TA centrifugal compressors. See Figure 1 for the system, as found in 2002. Three were running in parallel, with local controls, and one running in a segmented part of. .
Since performance degrades as the inlet valve closes back, 15% in this example project, one might suggest a hybrid system using a screw compressor for trim with the centrifugal. .
Picture two draft-horses, both pulling evenly on the same plow, in parallel. To make this happen, they need to be harnessed correctly,. .
Some load-sharing algorithms only balance the compressors. They don’t turn off a compressor at the point there is sufficient turn-down. This is okay for systems with flat loads. But if demand floats, a master control system able to start and stop, along.
[pdf] When the temperature of the oil measured by the sensor of the temperature control valve is lower than the action value (generally 70 - 85 degrees), the lubricating oil directly returns to the main engine from gas cylinder; when the oil temperature is higher than the action value, the temperature sensor of the temperature control valve is driven by the sleeve to push away the valve core, open the bypass valve, and let the lubricating oil enter the cooler for cooling (the higher the temperature, the larger the bypass valve is opened), and then the cooled lubricating oil to the main engine, so as to control the exhaust temperature of the air compressor during operation.
[pdf] 
We will start our trip through the loop at the same place we will finish: The oil sump. This reservoir is where oil is stored for use in the system. It is usually located in the lower section of a tank-like cylinder, that also houses components used in the air/oil separation process. This is normally a trouble-free component on. .
Oil from the sump flows through small entry passages around the outside of the filter base and is forced through an opening near the closed side of the filter casing, where it. .
This is our first stop in our trip through the system. This valve will direct our lubricant towards its next component based on temperature. Just. .
This component, like the radiator in your car, passes the fluid through tubing encased in a block of baffles, designed to optimize heat transfer. Most air-cooled air compressors have a high capacity fan which will force air through the baffles, and out of the cabinet,. .
Our next stop, assuming our lubricant has reached its operating temperature will be to the oil cooler. As our lubricant has been subjected to extreme friction and bears the brunt of temperature. Lubricating oil plays a crucial role in screw air compressors, primarily for lubrication, cooling, sealing, and noise reduction. The oil is drawn from the oil tank, filtered, and then enters the compressor. It lubricates the rotors and sealing components, reducing friction and wear.
[pdf] 
