1. Prepare the rock-drilling cavern, the specifications of which can be determined according to the method of drilling. Generally speaking, the height of the cavity is 2.6-2.8 meters when drilling a horizontal hole with a down-the-hole drill. When drilling upward, downward, or inclined holes, the width of the cavity is. .
1. When starting to work, carefully check whether the gas and water pipelines are firmly connected. Check for air leaks and water leaks. 2. Check whether the lubricator has been. .
When opening the hole, start the motor first, and pull the push handle of the manipulator after the transfer is normal. Make it get proper.
[pdf] 
A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud). The DTH hammer is one of the fastest ways to drill. .
DTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes downwards in surface-drilling. .
A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the. .
In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the fluid (air, water or drilling mud) used to. .
DTH products can be used in the following applications:• Mining- drill and blast holes in open pit mining, where the drill operator will drill several holes, then.
[pdf] 
A cutting process that involves spinning a drill bit to create a circular hole in solid materials is known as drilling. The drill bit is typically a multi-point rotary cutting tool. The bit is pressed against the workpiece and rotated at speeds between several hundred and several thousand revolutions per minute. This. .
A high-precision hole-finishing procedure carried out with a multi-edge tool is known as reaming. High penetration rates and shallow cuts involved in the reaming process enable close. .
A cutting process that entails enlarging an existing hole in a workpiece with a single-point cutting tool or boring head is known as boring.. .
The process of enlarging one end of the hole giving it a conical shape is called countersinking. Countersinking creates a V-shaped edge near the hole's surface. It is frequently employed for deburring drilled or tapped holes, and to ensure fasteners sit tightly in the. .
The process of enlarging a hole over a particular section in the workpiece for screw clearance using counterboring tools is known as counterboring. This creates a shallow and enlarged.
[pdf] 