1. Prepare the rock-drilling cavern, the specifications of which can be determined according to the method of drilling. Generally speaking, the height of the cavity is 2.6-2.8 meters when drilling a horizontal hole with a down-the-hole drill. When drilling upward, downward, or inclined holes, the width of the cavity is. .
1. When starting to work, carefully check whether the gas and water pipelines are firmly connected. Check for air leaks and water leaks. 2. Check whether the lubricator has been. .
When opening the hole, start the motor first, and pull the push handle of the manipulator after the transfer is normal. Make it get proper.
[pdf] Under normal conditions, a pressure switch or transducer controls the air pressure in a compressor. When the pressure switch reaches its cut-out set pressure, the compressor stops compressing air (unload) until it reaches the cut-in set pressure and starts compressing air again (load). The compressor cannot. .
A pressure relief valve in an air compressor opens when excessive pressure builds up inside the compressor, or the valve fails. .
A pressure relief valve may not come with a pressure vessel purchased separately from the air compressor. It is crucial to add a pressure relief valve to ensure safe operation. There are.
[pdf] When you turn on the engine, the battery powers the pistons in the cylinder up and down. The pistons push the air through the cylinders, into a combustion chamber where it is compressed. Compression forces the molecules in the air to move faster, which naturally heats the air. Fuel is then injected into the hot,. .
While the above process occurs, additional fuel is delivered by the system. The fuel is pumped from the fuel tank, passing through filters, a higher pressurization pump,. .
During the ignition process, air is also pumped to the cylinders. On some engines, this air passes through a simple air cleaner en route.
[pdf] 
