with Blast Hole Coupling and High Speed Water Swivel .
The chuck is accurately machined to assure perfect alignment. The jaws are held by two large, Allen set screws with countersunk heads in chuck body to make it impossible for them to catch the operator’s clothing while rotating. Successive pairs of. .
Exploded view showing method of jacking rear end plate out of motor housing for changing rotor blades .
The reversible air motor greatly speeds blast hole drilling by allowing rapid unscrewing of rod joints, after breaking joint with a wrench, and allowing for rapidly moving the chuck or blast hole coupling into drilling position. High bit speeds available where. .
The motor consists of a cylinder in which a rotor is mounted eccentrically, six slots in the rotor hold six laminated, phenolic blades which move in and out against the cylinder wall as the rotor revolves. These blades and the rotor are the only rotating parts. Ball bearings,.
[pdf] 
The longer your feed rail, the more important the addition of the energy chain becomes to the overall effectiveness of your machine. We offer a range of feed rail options from 6′ to 24′ for our Skid Steer and Excavator attachments depending on your specific project requirements. The addition of an energy. .
A common addition whenever a unit is equipped with a Doofor drilling motor, hydraulic clamp, or hydraulic breaker; this accessory comes in handy for routine maintenance of any. .
Making this accessory addition to your excavator or skid steer drilling attachment can really boost efficiency on the job site when dealing with. .
An easy add-on to any excavator attachment purchase, the addition of angle indication to your remote will provide you with a digital readout of your drill positioning. This feature is particularly beneficial when you are on a job that requires specific. .
A very helpful accessory whenever you are operating with casing, the addition of a hydraulic clamp and clamp breaker to your machine saves your.
[pdf] This robust head cuts the hard rock with single disc cutters. The cutters are located on the cutterhead in a geometric pattern that allows the disc to create a kerf (crush zone). The thrust at these kerfs creates fractures and cracks in the rock face, which ultimately form chips of rock. .
This will allow you to steer the machine and ensure accuracy of line and grade. The forward shield can be articulated in any direction necessary to allow accurate line and grade when. .
In the case of longer bores or difficult ground conditions, it may be necessary to go to the front of the cutterhead. In the case of longer bores or those in hard rock, the cutters will need to be changed. Whether or not they need to be changed is highly dependent on.
[pdf] 
