DTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes downwards in surface-drilling applications, its name originated from the fact that the percussion mechanism followed the bit down into the hole. Applications were later found for the DTH method underground, where the direction of drilling is generally upwards instead of do. OverviewA down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated. .
In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the flui. .
A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the quarry face in order to place the drill hole in.
[pdf] A tunnel boring machine (TBM), also known as a "mole" or a "worm", is a machine used to excavate tunnels. TBMs are an alternative to drilling and blasting methods and "hand mining", allowing more rapid excavation through hard rock, wet or dry soil, or sand (although each requires specialized TBM technologies). TBM-bored tunnel cross-sections extend up to 17.6 meters (58 ft. HistoryThe was developed by Sir to excavate the in 1825. However, this was only the invention of the shield concept and did not involve the constructio. .
TBMs typically consist of a rotating cutting wheel in front, called a cutter head, followed by a main bearing, a thrust system, a system to remove excavated material (muck), and support mechanisms. Machines v.
[pdf] 
A cutting process that involves spinning a drill bit to create a circular hole in solid materials is known as drilling. The drill bit is typically a multi-point rotary cutting tool. The bit is pressed against the workpiece and rotated at speeds between several hundred and several thousand revolutions per minute. This. .
A high-precision hole-finishing procedure carried out with a multi-edge tool is known as reaming. High penetration rates and shallow cuts involved in the reaming process enable close. .
A cutting process that entails enlarging an existing hole in a workpiece with a single-point cutting tool or boring head is known as boring.. .
The process of enlarging one end of the hole giving it a conical shape is called countersinking. Countersinking creates a V-shaped edge near the hole's surface. It is frequently employed for deburring drilled or tapped holes, and to ensure fasteners sit tightly in the. .
The process of enlarging a hole over a particular section in the workpiece for screw clearance using counterboring tools is known as counterboring. This creates a shallow and enlarged.
[pdf] 