HDD is a steerable tunneling method and is a two-stage process i.e. the pilot bore and the back reaming process, and can be used for small and large diameter pipelines. The. .
HAB utilizes a casing system fitted with a cutting head and rotating auger that is jacked into the earth from the launching shaft. As the auger proceeds, it transmits torque to the cutting head. The soil cuttings generated from the cutting head are transmitted back. .
Pipe ramming is carried out by using a percussive hammer attached to the end of the pipe or casing that pushes it into the soil. The leading. .
Also known as the compression method, the installation is carried out by pushing or pulling the pipe through the borehole created by a mole. The mole is a streamlined tool in.
[pdf] 
A cutting process that involves spinning a drill bit to create a circular hole in solid materials is known as drilling. The drill bit is typically a multi-point rotary cutting tool. The bit is pressed against the workpiece and rotated at speeds between several hundred and several thousand revolutions per minute. This. .
A high-precision hole-finishing procedure carried out with a multi-edge tool is known as reaming. High penetration rates and shallow cuts involved in the reaming process enable close. .
A cutting process that entails enlarging an existing hole in a workpiece with a single-point cutting tool or boring head is known as boring.. .
The process of enlarging one end of the hole giving it a conical shape is called countersinking. Countersinking creates a V-shaped edge near the hole's surface. It is frequently employed for deburring drilled or tapped holes, and to ensure fasteners sit tightly in the. .
The process of enlarging a hole over a particular section in the workpiece for screw clearance using counterboring tools is known as counterboring. This creates a shallow and enlarged.
[pdf] A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud). The DTH hammer is one of the fastest ways to drill hard rock. The system is thought to have been invented independently by Stenuick. Origin of the nameDTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes. .
In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the flui. .
A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the quarry face in order to place the drill hole in.
[pdf] 
