A down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or ). The DTH hammer is one of the fastest ways to drill hard rock. The system is thought to have been invented independently by Stenuic. This method utilizes a unique hammer drilling system where the percussion mechanism is located directly behind the drill bit at the bottom of the hole. The system consists of three main components: a drill bit, a hammer mechanism, and drill pipes.
[pdf] A pneumatic rock drill uses compressed air, a piledriver and a drill bit to pound into and pulverize hard surfaces. This powerful, efficient tool combines superior. .
An air-powered rock drill can meet the productivity and performance requirements of companies in a wide range of industries. .
As your full-service equipment rental partner, Herc Rentals can provide the best possible rental experience. All our rentals come from leading manufacturers with. .
Cut through the most challenging materials with a powerful, efficient air-powered rock drill from Herc Rentals. The knowledgeable rental specialists at any of our.
[pdf] 
Before diving into whether or not you should invest in a dual-rod machine, you need to know a little bit about the technology and its advantages for drilling in rock. “Dual-rod systems use two independently controlled drill rods— one within the other — during operation,” explained Michael. “While drilling out the pilot. .
One of the first factors to consider before choosing a dual-rod machine is the type of rock you’re working in. “Dual-rod drills are efficient in light- and. .
For most utility HDD work, small jobsites and the ability to quickly set up and tear down are essential to a crew’s operating efficiency. “Dual-rod machines can often be transported on. .
As you can see, the decision to add a dual-rod machine if more than 50% of your work is in rock, or to add a single-rod machine if less than 25% of your work is in rock, is pretty straightforward. However, if you fall someplace in the middle, then you have a lot to. .
Of course, how long a bore takes can often depend on the operator’s skills running the drill. Michael said the operator’s capabilities on the drill is another critical factor to consider when deciding between a single-rod and a dual-rod machine..
[pdf] 
