1. Prepare the rock-drilling cavern, the specifications of which can be determined according to the method of drilling. Generally speaking, the height of the cavity is 2.6-2.8 meters when drilling a horizontal hole with a down-the-hole drill. When drilling upward, downward, or inclined holes, the width of the cavity is. .
1. When starting to work, carefully check whether the gas and water pipelines are firmly connected. Check for air leaks and water leaks. 2. Check whether the lubricator has been. .
When opening the hole, start the motor first, and pull the push handle of the manipulator after the transfer is normal. Make it get proper.
[pdf] 
A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud). The DTH hammer is one of the fastest ways to drill. .
DTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes downwards in surface-drilling. .
A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the. .
In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the fluid (air, water or drilling mud) used to. .
DTH products can be used in the following applications:• Mining- drill and blast holes in open pit mining, where the drill operator will drill several holes, then.
[pdf] 
The series of DTH Drilling Machines produced by YG Machinery has wide applications in mining, water conservancy projects, photovoltaic piles, urban foundation pits, highway and railway construction, slope support, etc. YG crawler-type DTH drilling machine has completed the design of a full range of. .
Everyone should know about the down-the-hole drill carriage and even have used it. DTH drilling equipment is used in many constructions.. .
The rock drilling principle of a down-the-hole drill machine is the same as a heavy-duty rock drill rig. The difference is that the impact mechanism of the down-the-hole drill – is a down-the-hole impactor. It is installed at the front end of the drill rod, and at the bottom of. .
Among hot selling, the YG DTH drilling machine list, the YGL130, and YGM153 DTH drilling rigs are dual-power (diesel engine + electric. .
The pressure of all the company’s drill rigs has been set before leaving the factory: YGL type low-pressure crawler DTH drilling machine: left and right walking pressure: 13~14MPa,.
[pdf] 