DTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes downwards in surface-drilling applications, its name originated from the fact that the percussion mechanism followed the bit down into the hole. Applications were later found for the DTH method underground, where the direction of drilling is generally upwards instead of do. OverviewA down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated. .
In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the flui. .
A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the quarry face in order to place the drill hole in.
[pdf] 
The longer your feed rail, the more important the addition of the energy chain becomes to the overall effectiveness of your machine. We offer a range of feed rail options from 6′ to 24′ for our Skid Steer and Excavator attachments depending on your specific project requirements. The addition of an energy. .
A common addition whenever a unit is equipped with a Doofor drilling motor, hydraulic clamp, or hydraulic breaker; this accessory comes in handy for routine maintenance of any. .
Making this accessory addition to your excavator or skid steer drilling attachment can really boost efficiency on the job site when dealing with. .
An easy add-on to any excavator attachment purchase, the addition of angle indication to your remote will provide you with a digital readout of your drill positioning. This feature is particularly beneficial when you are on a job that requires specific. .
A very helpful accessory whenever you are operating with casing, the addition of a hydraulic clamp and clamp breaker to your machine saves your.
[pdf] This robust head cuts the hard rock with single disc cutters. The cutters are located on the cutterhead in a geometric pattern that allows the disc to create a kerf (crush zone). The thrust at these kerfs creates fractures and cracks in the rock face, which ultimately form chips of rock. .
This will allow you to steer the machine and ensure accuracy of line and grade. The forward shield can be articulated in any direction necessary to allow accurate line and grade when. .
In the case of longer bores or difficult ground conditions, it may be necessary to go to the front of the cutterhead. In the case of longer bores or those in hard rock, the cutters will need to be changed. Whether or not they need to be changed is highly dependent on.
[pdf] 