Which lubricator is used in Rock Drill yt28?

The Rock Drill is equipped with lubricator FY200C. Secoroc YT28 is intended to be used together with pusher leg FT160BC and FT160BD for different tunneling and work conditions. It is also designed for dry drilling or wet drilling mounted on rigs. Specification Pneumatic rock drill YT28

How do you use a rock drill?

When you have finished drilling Run the rock drill at medium speed when retracting the working tool from the drilled hole. Lay down the rock drill on a stone, wooden plank or similar object, so as to prevent drill cuttings and other foreign matter from entering the chuck. Turn off the water pressure before the air pressure.

How do you lubricate a rock drill & pusher leg?

The rock drill and pusher leg are lubricated with oil mixed with compressed air, which is taken to the parts that need continuous lubrication. Oil is metered into the compressed air using the FY250 lubricator connected to the air line.

Is yt28 suitable for drilling rocks?

YT28 is suitable for drilling rocks with a hardness of = 8~18. Page 4 Air-Leg Specifications Weight Length Feed Length Model (Kg) (mm) (mm) FT160 1668 1338 Installation and Lubrication Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet.

How often should a rock drill be inspected?

Turn off the water pressure before the air pressure. Once a week (after 40 hours of operation) Carry out a basic check of all functions of the drilling equipment. Once a month (after 200 hours of operation) Send the rock drill to a workshop for inspection.

How do you re-start a rock drill?

If powerful blow-cleaning of the drill hole is required, turn the throttle lever fully backwards beyond the stop position for extra blowing, whereupon the rock drill stops. This can be done during drilling. When the drill hole is clean, turn the throttle lever forwards again to re-start the rock drill. 11 When you have finished drilling