How do I Reset my compressor alarm?

The warning detected will be displayed and the compressor will continue to run. The warning can be reset by depressing set . It will illuminate when an alarm condition has occurred. The compressor will shutdown immediately. The alarm can be reset by The manual gives a list of alarms but does not mention the service alarm and what to service.

How does a screw compressor work?

A screw compressor can run loaded ('pumping air') or unloaded ('idle'). The inlet/loading valve opens and closes according to air demand. The inlet valve is controlled by a solenoid valve that supplies control air to the inlet/loading valve. Check solenoid valve coil and solenoid valve operation.

What should I do if my air compressor is too low?

If the capacity of the air compressor is really too low, check the following: Check differential pressure over oil separator. Replace separator when necessary. Check and replace compressed air filters (if installed). Compressor does not unload. Check if pressure switch is correctly set and working.

How do I know if my air compressor is working?

If you have a compressed air dryer, check the dewpoint. Check the current draw with a current clamp meter. If the motor draws exeessive current: Try to turn the compressor by hand. It should be possible to turn it around. It should turn around smoothly, without any 'hickups' (be sure to completely shut down the air compressor!).

What should I do if a compressor exploded?

ult in the rupturing or explosion of some system component. Relieve a l pressure internally to the compressor prior to servi ing. Do not depend on check valves to hold system pressure. Do not change the pressure setting of the pressure relief valve, restrict the function of the pressure rel

How do you check a compressor if a hole is capped?

. The original hole must be capped if another hole is used. Inspect incoming voltage to match the compressor’s spe ification. Inspect motor starter and overload heater sizes. Check all el or tightness and cleanliness.4.6 MOTOR ROTATION INSPECTIONMotor r