Which air/oil separator is suitable for oil-cooled screw compressors?

The air/oil separator AOS XT is suitable for use in oil-cooled screw compressors. AOS XT separators provide robust performance under a wide range of operating conditions. The improved separation performance significantly reduces the oil discharge and thus lowers the operating costs of the compressor.

Does a rotary screw compressor need an air-oil separator?

But while that oil is critical to the operation of an oil-flooded rotary screw compressor, it causes problems if it gets into the downstream tools—everything from pneumatic handling systems to nail guns—that are powered by the compressed air. As a result, the air-oil separator plays a critical role in removing that oil from the compressed air.

What is an oil separator & how does it work?

An oil separator does exactly what its name tells you it’s a filter within an air compressor system that separates oil from the compressed air to protect systems components and your air tools at the end of the line. If oil were to reach your pneumatic devices, serious damage could be caused which will result in short lifespan and greater costs.

Where is the oil separator located on a rotary screw compressor?

Air-oil separators typically used on rotary screw compressors, are located just after the compressed air leaves the compressor, installed in the compressors discharge line. This is so the oil can be removed and recycled back into the lubrication process.

What is an air compressor oil separator?

An air compressor oil separator is a key component in determining the air quality within a compressed air system. Oil, if able to get down your lines and reach your pneumatic tools, may cause serious damage and reduce your tools lifespan. Below we will take a look at oil separators: what they are, how they work and where you can find them!

How does a rotary screw air compressor oil separator work?

The oil that falls to the bottom of the sump is drained by a scavenge line. It goes through a filter (to remove impurities) and a cooler (to remove heat), then back to the main oil tank to start the process over again. Keeping your air-oil separator in good condition is essential for the performance of your rotary screw air compressor.