How do you Jack a compressor rotor?

Discharge Balance Piston and Bearings Use eye bolts to place the balance piston onto the male rotor shaft at the discharge end of the compressor Remove the eye bolts and fix a threaded rod into the end of the male rotor. Slide the male jacking tool up0 against the balance piston.

How do you remove a rotor casing from a compressor?

Loosen the hex bolts connecting inlet casing (B01) and rotor casing (B02) Apply jack bolts to the inlet casing to separate it from the rotor casing. Slide the inlet casing horizontally away from the compressor. Set the inlet casing on the work bench external surface up. Remove the retaining rings (L12) from both the male and female sides.

How does a screw compressor work?

A screw compressor can run loaded ('pumping air') or unloaded ('idle'). The inlet/loading valve opens and closes according to air demand. The inlet valve is controlled by a solenoid valve that supplies control air to the inlet/loading valve. Check solenoid valve coil and solenoid valve operation.

How do you remove a compressor shroud?

Do not forget the gloves while performing this. Step 2 – Compressor Shroud. Use a screwdriver (slot tip) to unscrew the shroud screws, and then pull the shroud halves away from each other by focusing at the locking tabs. The shroud is now removed. Step 3 – Dismantle The Pump Head. Disconnect the air outlet tube after lifting the valve plate.

How do you remove a compressor retaining ring?

Slide the inlet casing horizontally away from the compressor. Set the inlet casing on the work bench external surface up. Remove the retaining rings (L12) from both the male and female sides. Turn the inlet casing over so that the external surface is facing sown.

How do you remove a rotor from a hydraulic jack?

Use the press plate on to the threaded rods by using several nuts. Place a hydraulic jack horizontally between the press plate and the female rotor (A02). Press the female rotor out of the discharge rotor casings approximately half way.