It’s the key to part load efficiencies far superior to twin screw compressors. Capacity and volume slides move independently of. .
All of the gas that was trapped in the groove is pushed out. The volume of the groove is reduced to zero. Rotation The gas in the groove is at discharge Approximately 50%. .
As the groove increases to maximum, the gas flows into the open grooves. When the groove reaches its maximum length or volume, the groove is closed by the gaterotor and. .
The discharge port opens early in the cycle allowing only a small reduction in volume and a small increase in pressure. Rotation Minimum ➡.
[pdf] When you turn on the engine, the battery powers the pistons in the cylinder up and down. The pistons push the air through the cylinders, into a combustion chamber where it is compressed. Compression forces the molecules in the air to move faster, which naturally heats the air. Fuel is then injected into the hot,. .
While the above process occurs, additional fuel is delivered by the system. The fuel is pumped from the fuel tank, passing through filters, a higher pressurization pump,. .
During the ignition process, air is also pumped to the cylinders. On some engines, this air passes through a simple air cleaner en route.
[pdf] 
